Before installing the components, please carefully read all of the instructions contained in this manual. It is advisable to carefully follow the highlighted instructions. Failure to respect these instructions may cause unintentional harm or damage to the components.
SAFETY CONSIDERATIONS
1. Make sure your car has a 12 volt DC negative ground electrical system.
2. Before installing the DRC MP CAN, turn off the source and all other electronic devices in the audio system to prevent any possible damage.
3. Do not install components inside the engine compartment or expose them to water, excessive humidity, dust or dirt.
4. Never run cables outside the vehicle or install the amplifier next to mechanical or electronic devices.
5. Install the DRC MP CAN only in areas of the vehicle where internal temperature is between 0°C (32°F) and 55°C (131°F).
6. Make sure that the positioning does not interfere with the proper functioning of the car’s electrical or mechanical devices.
After installation, verify that the light sensor on the front panel of the DRC MP is not obscured.
7. Make sure not to short-circuit the cable of the DRC MP CAN during installation and connection and only use the cable provided in the giftbox.
8. Use extreme caution when cutting or drilling on the metal sheet/chassis, making sure that in the area concerned there is no electrical wiring or structural element of the car. If necessary, use the appropriate mounting bracket.
9. Use rubber grommets to protect the wire when running through holes in metal and use proper materials if close to heat-generating devices.