W-DRIVE is a bench setup device and its use does not require installation in the car.
W-DRIVE works with the bit Drive configuration platform and allows the configuration of the DSP connected. The connection between W-Drive and device can be made via USB or ADC connection.
Its use is necessary for tuning the DSP, avoiding the use of the USB cable, allowing greater ease of handling using a non-wired remote connection. All setup options of the Bit Drive software are therefore available except for:
◼︎Input levels auto-tuning.
◼︎Inputs De Phase.
◼︎Inputs/Outputs electric RTA.
Before using the W-DRIVE please carefully read all of the instructions contained in this manual. It is advisable to carefully follow the instructions provided. Failure to comply with these instructions may cause unintentional harm or damage to the appliance or to the devices connected to it.
GENERAL PRECAUTIONS
1. Make sure your car has a 12VDC / 24VDC negative ground electrical system
2. Do not perform measurements inside the engine compartment or in areas exposed to water, excessive humidity, dust or dirt
3. Perform the measurements only in areas where internal temperature is between 0°C (32°F) and 55°C (131°F).
4. Make sure the location you chose does not affect the correct functioning of the vehicle’s mechanical and electrical devices.
5. Use the power adapters provided in the package.
6. Make sure the power cable does not short circuit during installation and connection.
7. To facilitate measurement operations, route the connection cables in the best possible way, using cables supplied in the product packaging, referring to the instructions in the ADVANCED MANUAL.